NOTE! This site uses cookies and similar technologies.

If you not change browser settings, you agree to it. Learn more

I understand
for conventional systems

I-TAC-WP



Hydraulic Solenoid Valve Control Unit – IP 68 and Anti-Shock approved

I-TAC-WP is an IP 68 and anti-shock control unit housed inside a resin-bonded techno polymer box and integrated on the hydraulic solenoid valve. It is designed to control hydraulic actuators or cylinders and is installed directly on the manifold able to get hydraulic oil supply from an HPU and to deliver it to through A and B pipes. Powered from redundant power feedings 230 Vac, the TAC-WP foresees an interface towards the control posts through a redunded BUS. It is further possible to control and command directly from TAC-WP through a PC tablet. All connected control posts are managed following a priority hierarchy able to avoid any commands override. TAC-WP joined to I-COMM-L cards manages the RPC function (Reduction Pressure Control); this function guarantees the solenoid valve drainage reduction when none valve is in command.

  • Redundant supervised power supply
  • Power supply 115/230 Vac with switching insulated at 3Kv
  • 3 Serials RS485 (max 115.200 baud) isolated at 3Kv
  • Protocol MODBUS RTU standard
  • 2 Digital Inputs supervised
  • 1 Analog Inputs
  • Up to 32 units in parallel
  • IP68 protection degree

Description

Values

Power Supply supervised

Redundant 115/230 Vac 50-60 Hz

Consumption

5 W

Solenoid consumption

30 W

Operating ambient temperature

+5 to +55 °C

Max. Ambient Temperature

70°C

Min. Ambient Temperature

5 °C

Processor

ARM

Ram

128 KB

Flash

128 MB

Operating system

Real time CMX

Serial interfaces

3x RS485 (max 115.200 baud) isolated at 3Kv

Digital Inputs supervised

2x Free contact

Analog Input

1x 4 - 20 mA

Grade of protection

IP68 3Bar for 72 hours

Software update and config.

with software MASSO IND MIST

Approvals

IEC 60092-504 ED 3.0
IACS E10 Rev.5

More in this category: « I-COMM-L I-TAC-WP-MB8 »
Realizzazione CMS